What is Reddit's opinion of Install Bay 89-00-9031 ABS Plastic 12 X 12 X 1/8-Inch?

From 3.5 billion Reddit comments

it should make no difference as it is below the air filter. if you really wanted to replace it you could use Install Bay 89-00-9031 ABS Plastic 12 X 12 X 1/8-Inch and just caulk or rivet it on

No that's scored for making speaker mounts. Just get some simple ABS plastic. I'm not sure how thick it should be. ABS is pretty strong so I think an 1/8 inch should be fine but I would get a second opinion for thickness just to be sure.

I used this sheet ABS to make chassis rails and other mounting bits pretty successfully (i just used snips, a small hand saw or hobby saw and files to shape it):

https://www.amazon.com/dp/B0007WTF02?ref=ppx_pop_mob_ap_share

I also used these bits and pin vise for drilling out screw holes:

https://www.amazon.com/dp/B07ZVSJZXN?ref=ppx_pop_mob_ap_share

https://www.amazon.com/dp/B000CSCQ98?ref=ppx_pop_mob_ap_share

Yeah I suppose there's that risk with it being paper and doing water changes.

What about something like this?

https://www.amazon.com/dp/B0007WTF02/ref=cm_sw_r_awdo_ZXA4EH9KD6R3K21S5SWD

No worries. I used these carriage bolts:

https://www.homedepot.ca/product/paulin-5-16-inch-x-2-inch-carriage-bolt-zinc-plated-unc/1000135749

These wing knobs:

https://www.homedepot.ca/product/paulin-5-16-3-wing-knob-1pc/1000144023

And this plastic from amazon:

https://www.amazon.ca/dp/B0007WTF02/ref=cm_sw_r_cp_apap_83LF76vlodImu

If I were to do it again, I'd buy kydex instead.

Thank you! I appreciate the support.

I used ABS plastic from amazon for the board:

Install Bay 89-00-9031 ABS Plastic 12 X 12 X 1/8-Inch