What are /r/FPVFreestyle's favorite Products & Services?

From 3.5 billion Reddit comments

https://smile.amazon.com/dp/B07RY5RKK7/ref=cm_sw_r_cp_apa_i_3g3cFb0Q8DRRQ This is the one I have. It's not the best. But its safer and stable than alot of cheaper made products. But you should get a battery tester.

Here is the 30A Eachine ESC that comes with it: https://www.banggood.com/Eachine-Wizard-X220S-FPV-Racer-Spare-Part-4-in-1-30A-ESC-BLHeli_S-2-5S-Dshot600-p-1172948.html?cur_warehouse=CN

But any 30mm stack size will do the trick. The only thing you want to watch though, is if they will work with your FC. There's a lot of incompatability with JST pin layouts and some wont have the solder pads on either the FC or the ESC to make them work.

If you don't know what to look for yourself, it's safest to just use what it came with so then there's no surprises.

https://www.printables.com/model/157216-isdt-battgo-usb-c-thunderbolt-adapter

Requires a "PD trigger module" to tell the supply to send 20v. Also an XT60.

The trigger module I used : https://www.amazon.com/dp/B09MK4RT5Y?psc=1&ref=ppx_yo2_dt_b_product_details

Plug and usb-c port are press fit and wired to each other. Back is glued on.

Check your polarity!!

Thanks so much. I purchased this, then they added its the V1 (Straight from iflight)

https://www.amazon.com/gp/product/B0936ZNQ31/ref=ppx_yo_dt_b_asin_title_o01_s00?ie=UTF8&psc=1

In the answered questions, it says its the v1. The frame, as far as I can tell matches the V2. Only thing I can think of is the V2 current has more leds. But again, sooooo hard for me to figure out what the deal is. Once i do, ill make a video:)

Thanks again for your time.

50-70hz is usually propwash fyi. Against what you would think, LOWERING your filters.usually helps noise in the sub 100hz range (less latency), at the expense of noise in the 200+ hz range (electrical and mechanical noise). Arm flex can contribute a ton, but either way get a pack of these and pop them on as I described.

Make sure you run fresh carbon if it gets all "rubbery" and if you can deal with the weight, brave your arms (if your frame has braces available, the tp3 does).

I've been running no braces at 99g with a cap and it's glorious.

https://www.amazon.com/pcs-Panasonic-FR-Capacitors-330uf/dp/B07F1D9BDH

Doesn’t hurt to have an assortment of M2 socket head screws. Amazon link

https://www.amazon.com/Battery-Tester-Voltage-Buzzer-Alarm/dp/B005GJCJOA

lipo alarm for $3. You do have to wait for the battery to go low, and if you don't find it by the time the battery goes dead you are screwed, and also the lipo alarm could break or fall off in a crash (I put it under the battery strap).