This might not be the solution you’re looking for but I checked Amazon and it does appear you can buy a replacement handle
It comes from where the bars(? The things that that rollers a foot pedals are mounted to) connect to what I’d call the crank arms (like on a bike). Basically the spindles on the crank arms are about a millimeter or two longer than the part of the bars that move around it. If the crank arms aren’t 100% true (which mine aren’t) the bars slide side to side on the spindle making a loud klang when they hit the outer edge.
I bought some of these Teflon washers off eBay.
And put them between the end of the bars and the hex bolt and metal washer on the outside ends.
I had to ream them out just a bit with a deburring tool until the were big enough to fit on spindles.
It's the latter. The blaze should have some empty slots for additional rods. They sell pairs of 50lb rods for $100 on Amazon.
https://www.amazon.com/Bowflex-95146-310-Pound-Rod-Upgrade/dp/B000F5NL0Q/
JDDZ SPORTS Pull up Resistance and Assist Bands, Workout Bands | Powerlifting Bands,Mobility Stretch Bands,Exercise Band for Body Fitness Training, Chin Ups, Stretch https://www.amazon.com/dp/B07YDH1N6D/ref=cm_sw_r_cp_api_glt_fabc_NZGSD2VBG00S0QEZCG7D?_encoding=UTF8&psc=1
Those are good.
Amazon has lots of option. I prefer these instead of the ones with hooks.
Hi,
You could always get one of these . . .
and here's a link with a picture of it on a bike:
Late to the party but I also found the seat uncomfortable so I purchased a new one. The new one is much more comfortable and the installation was less than 10 minutes.
Amazon link: https://www.amazon.com/gp/product/B08B5XTL1F/ref=ppx_yo_dt_b_asin_image_o03_s00?ie=UTF8&psc=1