What are /r/gmc's favorite Products & Services?

From 3.5 billion Reddit comments

I was told, by detailer at dealership to use the following by Adam’s and it’s been perfect for my AT4… no shine or residue.

Adam's Microban Interior Detailer

https://www.amazon.com/dp/B006MYFB9S?ref=ppx_pop_mob_ap_share

You can also use a cassette to Aux adapter and then plug the 3.5mm into your phone...of course you'll have to worry about using a 3.5 mm jack on your phone...may require a dongle.

Helps when I drop the link.

SIRIUSLED RLS 7440 7440A Built in Resistor Anti Hyper flashing LED Bulb Turn Signal Light Amber Orange Color Full Aluminum Body Single Filament Error Free Pack of 2 https://smile.amazon.com/dp/B084C23DT1/ref=cm_sw_r_cp_api_glt_i_W9Z5PW6TV4M8ZV1GH241?_encoding=UTF8&psc=1

Does the weather stripping ha e holes in the back which attach to the clips that plug into the frame?

Use bigger clips

https://www.amazon.com/Energizer-Inverter-Modified-Converter-Outlets/dp/B08CZ38ZXR/

A nice 1100 watt inverter you hard wire in, can have under the dash and will support your laptop and printer with room to spare. It's the one I use in my truck and has held up well through 3 vehicles now.

I had a similar problem on my 2010, but I don't remember any of the engine codes. After seeing some advice on some GM forums, I replaced the 175 amp "Mega fuse" near the battery. This 100% solved my issues. Its cheap enough that it may be worth a shot for you. Good luck!

https://www.amazon.com/gp/product/B00GV88X86/ref=ppx\_yo\_dt\_b\_search\_asin\_title?ie=UTF8&psc=1

here is the link to the camera on sale: Amazon special- $69 I got an extra $20 off, but I don't know how, or if everyone will. It was an option on the info page for the camera: "check this box for an extra $20 off"

Check out bulbfacts.com they review headlight bulbs from different price points. In my Canyon I ended up upgrading to the Katana LED from Amazon. So far I have only swapped the low beam but I will probably swap the high beam soon too. Katana H11

YOOHE 22PCS Auto Body Paintless Dent Removal Tools Kit Bridge Dent Puller Kits with Hot Melt Glue Gun and Glue Sticks https://www.amazon.com/dp/B0784S9KPD/ref=cm_sw_r_cp_api_glt_fabc_WDAT28G7JVBGE7AH7BP2?_encoding=UTF8&psc=1

I’ve used it to pull dents this size. It does the job.

According to this article it isn’t available on the Canyon. https://www.macrumors.com/2020/03/05/gm-chevy-wireless-carplay-2021/ you can buy an adapter that makes any car wireless. https://www.amazon.com/dp/B08CRRPFB7/ref=cm_sw_r_cp_api_glt_fabc_2KB1NRXV9XW1RDTCS9C3

My hubby and I have 2020 Terrains, but I bet the same would work for you. We both use the vertical cargo net - clips onto the rear hooks fine. This is the Terrain, I’m sure something similar can be had for an Arcadia. https://www.amazon.com/gp/product/B07FKTYC8V/ref=ppx_yo_dt_b_asin_title_o07_s01?ie=UTF8&psc=1 We also have cargo containers that expand out - but fold up and can be stowed under the hatch when not needed. https://www.amazon.com/TRUNKCRATEPRO-Compartments-Collapsible-Organizer-Recommended/dp/B07CZMDFFW. We have cargo mats in the back that prevents the cargo containers from ‘sticking’ to the carpet floor mats, but they can be latched down with the straps. No issue. We love them. Just hauled two propane gas tanks to be refilled in these no problem.

I recently had similar problem on my 2013 sierra. My power got cut and the engine went into limp mode. Cleaned throttle body, marginal improvement and still low power mode. My tachometer was also not acting properly so i replaced the little black dohickey (throttle position sensor if i remember) clipped to the side of the throttle body. This almost fixed the problem, i no longer was in limp mode but the tachometer was not stable at all times and shift points were rough. So in the end i replaced the whole throttle body and problem solved! The only extra step I needed to take was relearning the throttle position in the throttle body. I purchased this: https://www.amazon.com/dp/B07RMYN7ZL?psc=1&ref=ppx_pop_dt_b_product_details

The reason I purchased the diagnostic and reset tool is because my local shops all wanted to charge me 300 dollars to have them take 30 seconds and hit the fancy reset button on the controller.

When looking up the engine error code number it was always telling me faulty MAF sensor but in reality it was not a problem with my MAF sensor. I know this because it was the thing i replaced first and nothing changed.

TL;DR Replacing the whole throttle body worked for me.

Side note: I do not regret purchasing the diagnostic tool. I've actually have been able to use it a far amount and it has already paid itself off. Simple example was when my brothers 2018 equinox threw an error code on a cold morning last winter that put the diesel engine in limp mode and I was able to reset and clear the code and the problem was solved. (He put the hammer down on the throttle before the engine had enough time to warm up).